Printing procedure
Basic Printing W orkow
Printing procedure
Loading and Printing on Rolls
These are the basic steps for loading and printing on rolls.
Follow the steps below to switch to a new roll or a roll of a dif ferent type or width before printing.
Note
• If a sheet is loaded in the T op Paper Feed Slot , remove it before this procedure. ( → P .146)
• Before printing banners or other long documents, spread a clean cloth or paper on the oor or use the
Output Stacker to prevent the printed surface from becoming dirty from the oor after printing.
• If you will wait for the ink to dry after printing and simply eject the document, you can deactivate
automatic cutting and print a cut line instead. ( → P .129)
1. T urn the printer on. (→P .19)
2. Select roll paper as the paper source. (→P .1 15)
80 Basic Printing W orkow
To Next Page
Loading...
Need help?
General