Cause Corrective Action
Paper has been loaded
askew, or warped paper
has been loaded.
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
Insufficient paper for job
Insufficient paper for job
Cause Corrective Action
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.
Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
Press ▲ or ▼ to select Change Paper, and
then press the OK button to stop printing.
Either change the printer driver Paper Source
setting or the GL2 Settings > Paper Source
setting in the printer menu or replace the roll
with a roll that has enough paper for the print
job, and then try printing again.
(See "Removing the Roll from the Print-
er.") ➔P.343
(See "Loading Rolls in the Printer.") ➔ P.339
Press ▲ or ▼ and select Stop Printing or
press the Stop button to stop printing.
This paper cannot be used.
This paper cannot be used.
Cause Corrective Action
Paper smaller than the printer's minimum supported
size has been loaded.
Push the Release Lever back and load paper of the correct size.
(See "Paper Sizes.") ➔P.326
Paper has been loaded that is too small to print the
test pattern for printhead adjustment or nozzle check-
ing.
Push the Release Lever back and load unused paper of A4 size or larger.
More than one sheet may be required depending on the adjustment.
Roll printing is selected.
Roll printing is selected.
Cause Corrective Action
You have attempted to print on a roll,
but no roll is loaded.
Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll,
and then print.
(See "Attaching the Roll Holder to Rolls.") ➔ P.336
(See "Loading Rolls in the Printer.") ➔ P.339
Press ▲ or ▼ and select Stop Printing or press the Stop button to stop printing.
Roll printing is selected, but sheets are loaded.
Roll printing is selected, but sheets are loaded.
Cause Corrective Action
A print job for rolls was received when a
sheet is loaded.
Follow these steps to load and print on a roll.
1.
Press ▲ or ▼ to select Eject Cut Sheet, press the OK button, and remove the sheet.
(See "Removing Sheets.") ➔P.360
2.
Load a new roll.
(See "Loading Rolls in the Printer.") ➔ P.339
The printer now starts printing the print job.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
The roll is empty.
The roll is empty.
Cause Corrective Action
The roll is empty. Follow these steps to replace the used roll with a new roll of the same type and size.
iPF780
Insucient paper for job
User's Guide
Error Message Messages regarding paper
559
To Next Page
Loading...
Need help?
General
Weight and Dimensions
