Scanning Information
Introduction
You can place an original either vertically or horizontally. Always align the top edge of your
original with the back edge of the glass plate (by the arrow in the top left corner) or the back edge
of the ADF.
The size of the original is automatically detected, and the document is scanned.
The machine cannot always detect the size of the original if it is a non-standard paper size, such
as a book. In this case, specify the size of the original.
Orientation on the Glass Plate
When you put an original on the glass plate, always put the original face down on the glass plate.
NOTE
If the top edge of the original is not aligned with the back edge of the glass plate (by the arrow in
the top left corner), your original may not be scanned correctly.
Placement on the glass plate
Placement Illustration
Vertical placement
Horizontal placement
Orientation in the ADF
Placement in the ADF
Placement
Illustration
Vertical placement
4
Scanning Information
Chapter 6 - Prepare the jobs
101
Canon varioPRINT DP line
To Next Page
Loading...
Need help?
General
