Create a Hotfolder
Introduction
The information in this section is intended for system administrator.
Before you begin
The hotfolder function must be activated. Otherwise, the system administrator must activate the
hotfolder function first.
Procedure
NOTE
This procedure requires the system administrator password for the Settings Editor.
1.
Open your web browser and enter the host name or IP address of your PRISMAsync controller.
2.
Select [Workflow] -> [Hotfolders].
3.
Click [Add].
4.
Give the hotfolder a logical name.
A logical name helps you to recognize the type of jobs you want to process using this hotfolder.
5.
Select the automated workflow to which you want to link the hotfolder.
6.
Click [OK].
Create a Hotfolder
68
Chapter 5 - Prepare the print system
Canon varioPRINT DP line
To Next Page
Loading...
Need help?
General
