Change the Use of Separator Sheets
Introduction
Separator sheets are empty sheets that are automatically inserted before each new set or job to
separate two sets or jobs. In the Settings Editor you can define the media that must be used as
separator sheets. You can also specify after how many sets you want to include a separator sheet
in the stack. The use of separator sheets can be enabled via the automated workflows in the
Settings Editor. However, you can change this setting through the control panel.
NOTE
You cannot change this setting for the active print job
.
Procedure
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or select a
DocBox.
2.
Touch the job you want to change.
3.
Touch [Properties], or double-tap the job to open the [Properties] window.
4.
Touch the [Separator sheets] button to toggle between [On] and [Off].
5.
Touch [OK].
Change the Use of Separator Sheets
Chapter 9 - Carry Out Print Jobs
185
Canon varioPRINT DP line
To Next Page
Loading...
Need help?
General
