Change the Settings for Covers
Introduction
When front covers or back covers are required, the settings are usually set in the printer driver,
for example. However, you can view and change the settings for the covers via the control panel.
You can change the following settings for both the front cover and the back cover separately.
• Enable or disable the use of a cover.
• Select the desired media from the media catalog.
• Indicate whether the cover must be left empty, printed one-sided, or printed two-sided.
NOTE
You cannot change this setting for the active print job
.
Procedure
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or select a
DocBox.
2.
Touch the job you want to change.
3.
Touch [Properties], or double-tap the job to open the [Properties] window.
4.
Touch the [Cover] button.
5.
Make the required changes.
6.
Press [OK].
Change the Settings for Covers
Chapter 9 - Carry Out Print Jobs
173
Canon varioPRINT DP line
To Next Page
Loading...
Need help?
General
