1-4
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the Cisco Phone Proxy
Licensing Requirements for the Phone Proxy
• Cisco Unified IP Phone 7941G-GE
• Cisco Unified IP Phone 7940 (SCCP protocol support only)
• Cisco Unified Wireless IP Phone 7921
• Cisco Unified Wireless IP Phone 7925
Note To support Cisco Unified Wireless IP Phone 7925, you must also configure MIC or LSC on the
IP phone so that it properly works with the phone proxy.
• CIPC for softphones ( CIPC versions with Authenticated mode only)
Note The Cisco IP Communicator is supported with the phone proxy VLAN Traversal in
authenticated TLS mode. We do not recommend it for remote access because SRTP/TLS is not
supported currently on the Cisco IP Communicator.
Note The ASA supports inspection of traffic from Cisco IP Phones running SCCP protocol version 19 and
earlier.
Licensing Requirements for the Phone Proxy
The Cisco Phone Proxy feature supported by the ASA require a Unified Communications Proxy license.
The following table shows the Unified Communications Proxy license details by platform:
Note This feature is not available on No Payload Encryption models.
Model License Requirement
1
ASA 5505 Base License and Security Plus License: 2 sessions.
Optional license: 24 sessions.
ASA 5510 Base License and Security Plus License: 2 sessions.
Optional licenses: 24, 50, or 100 sessions.
ASA 5520 Base License: 2 sessions.
Optional licenses: 24, 50, 100, 250, 500, 750, or 1000 sessions.
ASA 5540 Base License: 2 sessions.
Optional licenses: 24, 50, 100, 250, 500, 750, 1000, or 2000 sessions.
ASA 5550 Base License: 2 sessions.
Optional licenses: 24, 50, 100, 250, 500, 750, 1000, 2000, or 3000 sessions.
ASA 5580 Base License: 2 sessions.
Optional licenses: 24, 50, 100, 250, 500, 750, 1000, 2000, 3000, 5000, or 10,000 sessions.
2
To Next Page
Loading...
Need help?
General