1-27
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Cisco Intercompany Media Engine Proxy
Troubleshooting Cisco Intercompany Media Engine Proxy
Troubleshooting Cisco Intercompany Media Engine Proxy
Feature History for Cisco Intercompany Media Engine
Proxy
Table 1-1 lists the release history for this feature.
Table 1-1 Feature History for Cisco Phone Proxy
Feature Name Releases Feature Information
Cisco Intercompany Media Engine Proxy 8.3(1) The Cisco Intercompany Media Engine Proxy was
introduced.
The following commands were added to the CLI to support
configuration of this new feature.
[no] uc-ime uc_ime_name
[no] fallback hold-down | monitoring timer value
[no] fallback sensitivity-file filename
[no] mapping-service listening-interface ifc_name
[listening-port port] uc-ime-interface b2b-ifc
[no] ticket epoch epoch password pwd
[no] ucm address ip_addr trunk-security-mode
nonsecure | secure
clear configure uc-ime [uc_ime_name]
[no] debug uc-ime [mapping-service | media |
notification | rma | signaling] [errors | events]
show uc-ime
show running-config [all] uc-ime [uc_ime_map]
The following command was updated by adding options for
the UC-IME proxy.
inspect sip uc-ime uc-ime-name tls-proxy tls-proxy-name
To Next Page
Loading...
Need help?
General