1-13
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the ASA CSC Module
Monitoring the CSC SSM
What to Do Next
See the “Monitoring the CSC SSM” section on page 1-13.
Monitoring the CSC SSM
To check the status of a module, enter one of the following commands:
Examples
The following is sample output from the show module command for an ASA with a CSC SSM installed:
hostname# show module
Mod Card Type Model Serial No.
--- -------------------------------------------- ------------------ -----------
0 ASA 5520 Adaptive Security Appliance ASA5520 JMX1241L05S
1 ASA 5500 Series Content Security Services Mo ASA-SSM-CSC-10 AF1234BQQL
Mod SSM Application Name Status SSM Application Version
--- ------------------------------ ---------------- --------------------------
1 CSC SSM Down 6.2.1599.0
The following is sample output from the show module details command, which provides additional
information about an ASA with a CSC SSM installed:
hostname# show module 1 details
Getting details from the Service Module, please wait...
ASA 5500 Series Security Services Module-20
Model: ASA-SSM-20
Hardware version: 1.0
Serial Number: JAF10333331
Firmware version: 1.0(10)0
Software version: Trend Micro InterScan Security Module Version 6.2
App. name: Trend Micro InterScan Security Module
App. version: Version 6.2
Data plane Status: Up
Status: Up
HTTP Service: Up
Mail Service: Up
FTP Service: Up
Activated: Yes
Mgmt IP addr: 209.165.200.225
Mgmt web port: 8443
The following is sample output from the show module recover command, which includes recovery
details for an ASA with a CSC SSM installed:
hostname# show module 1 recover
Module 1 recover parameters. . .
Boot Recovery Image: Yes
Image URL: tftp://10.21.18.1/ids-oldimg
Port IP Address: 209.165.200.230
Command Purpose
show module
Displays the status.
show module 1 details
Displays additional status information.
show module 1 recover
Displays the network parameters for transferring an image to the module.
To Next Page
Loading...
Need help?
General