Device(config-igmp-profile)# ?
IGMP profile configuration commands:
deny matching addresses are denied
exit Exit from igmp profile configuration mode
no Negate a command or set its defaults
permit matching addresses are permitted
range add a range to the set
Device(config-igmp-profile)# range 172.16.5.1
Device(config-igmp-profile)# exit
Device(config)#
Device(config)# interface gigabitEthernet 2/0/10
Device(config-if)# ip igmp filter 10
Examples: Configuring IGMP Snooping
This example shows how to enable a static connection to a multicast router:
Device# configure terminal
Device(config)# ip igmp snooping vlan 200 mrouter interface gigabitethernet1/0/2
Device(config)# end
This example shows how to statically configure a host on a port:
Device# configure terminal
Device(config)# ip igmp snooping vlan 105 static 224.2.4.12 interface gigabitethernet1/0/1
Device(config)# end
This example shows how to enable IGMP Immediate Leave on VLAN 130:
Device# configure terminal
Device(config)# ip igmp snooping vlan 130 immediate-leave
Device(config)# end
This example shows how to set the IGMP snooping querier source address to 10.0.0.64:
Device# configure terminal
Device(config)# ip igmp snooping querier 10.0.0.64
Device(config)# end
This example shows how to set the IGMP snooping querier maximum response time to 25 seconds:
Device# configure terminal
Device(config)# ip igmp snooping querier query-interval 25
Device(config)# end
This example shows how to set the IGMP snooping querier timeout to 60 seconds:
Device# configure terminal
Device(config)# ip igmp snooping querier timer expiry 60
Device(config)# end
This example shows how to set the IGMP snooping querier feature to Version 2:
Device# configure terminal
Device(config)# no ip igmp snooping querier version 2
Device(config)# end
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
94 OL-32598-01
Configuring IGMP
Examples: Configuring IGMP Snooping
To Next Page
Loading...
Need help?
General