Related Topics
PIM MIB Extensions for SNMP Traps for IP Multicast, on page 189
Example Enabling PIM MIB Extensions for IP Multicast, on page 192
Configuration Examples for PIM MIB Extensions
Example Enabling PIM MIB Extensions for IP Multicast
The following example shows how to configure a router to generate notifications indicating that a PIM interface
of the router has been enabled. The first line configures PIM traps to be sent as SNMP v2c traps to the host
with IP address 10.0.0.1. The second line configures the router to send the neighbor-change class of trap
notification to the host.
snmp-server host 10.0.0.1 traps version 2c public pim
snmp-server enable traps pim neighbor-change
interface ethernet0/0
ip pim sparse-dense-mode
Related Topics
Enabling PIM MIB Extensions for IP Multicast, on page 190
PIM MIB Extensions for SNMP Traps for IP Multicast, on page 189
Additional References
Related Documents
Document TitleRelated Topic
Cisco IOS Master Commands List, All Releases
Cisco IOS commands
Cisco IOS IP Multicast Command Reference
IP multicast commands
Standards and RFCs
TitleStandard/RFC
A New Proposal for Bi-directional PIM
draft-kouvelas-pim-bidir-new-00.txt
Host Extensions for IP Multicasting
RFC 1112
Address Allocation for Private Internets
RFC 1918
GLOP Addressing in 233/8
RFC 2770
An Overview of Source-Specific Multicast (SSM)
RFC 3569
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
192 OL-32598-01
Configuring PIM MIB Extension for IP Multicast
Configuration Examples for PIM MIB Extensions
To Next Page
Loading...
Need help?
General