CHAPTER 14
IP Multicast Optimization: Optimizing PIM Sparse
Mode in a Large IP Multicast Deployment
•
Finding Feature Information, page 329
•
Prerequisites for Optimizing PIM Sparse Mode in a Large IP Multicast Deployment, page 329
•
Information About Optimizing PIM Sparse Mode in a Large IP Multicast Deployment, page 330
•
How to Optimize PIM Sparse Mode in a Large IP Multicast Deployment, page 333
•
Configuration Examples for Optimizing PIM Sparse Mode in a Large Multicast Deployment, page 335
•
Additional References, page 336
•
Feature History and Information for Optimizing PIM Sparse Mode in a Large IP Multicast Deployment,
page 336
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Optimizing PIM Sparse Mode in a Large IP
Multicast Deployment
•
You must have PIM sparse mode running in your network.
•
If you plan to use a group list to control to which groups the shortest-path tree (SPT) threshold applies,
you must have configured your access list before performing the task.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 329
To Next Page
Loading...
Need help?
General