PurposeCommand or Action
Verifies your entries.show running-config
Example:
Device# show running-config
Step 8
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config
Step 9
startup-config
Applying IGMP Profiles (CLI)
To control access as defined in an IGMP profile, you have to apply the profile to the appropriate interfaces.
You can apply IGMP profiles only to Layer 2 access ports; you cannot apply IGMP profiles to routed ports
or SVIs. You cannot apply profiles to ports that belong to an EtherChannel port group. You can apply a profile
to multiple interfaces, but each interface can have only one profile applied to it.
Follow these steps to apply an IGMP profile to a switch port:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
ip igmp filter profile number
5.
end
6.
show running-config
7.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Device> enable
Step 1
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 61
Configuring IGMP
Applying IGMP Profiles (CLI)
To Next Page
Loading...
Need help?
General