usergroup
To configure a user group and associate it with a set of task groups, and to enter user group configuration
mode, use the usergroup command. To delete a user group, or to delete a task-group association with the
specified user group, use the no form of this command.
usergroup usergroup-name
no usergroup usergroup-name
Syntax Description
Name of the user group. The usergroup-name argument can be only one word.
Spaces and quotation marks are not allowed.
usergroup-name
Command Default
Five predefined user groups are available by default.
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.Release 2.0
Support was added to display all user groups in global configuration
mode.
Release 3.3.0
Usage Guidelines
User groups are configured with the command parameters for a set of users, such as task groups. You can
remove specific user groups by using the no form of the usergroup command. You can remove the user group
itself by using the no form of the command without giving any parameters. Deleting a user group that is still
referenced in the system results in a warning and a rejection of the deletion.
Use the inherit usergroup, on page 36 command to copy permissions from other user groups. The user group
is inherited by the parent group and forms a union of all task IDs specified in those groups. Circular inclusions
are detected and rejected. User groups cannot inherit properties from predefined groups, such as root-system
and owner-sdr.
From global configuration mode, you can display all the configured user groups. However, you cannot display
all the configured user groups in usergroup configuration mode.
Task ID
OperationsTask ID
read, writeaaa
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
OL-24740-01 117
Authentication, Authorization, and Accounting Commands
usergroup
To Next Page
Loading...
Need help?
General
