Cisco CRS User Manual

authorization (line)
To enable authentication, authorization, and accounting (AAA) authorization for a specific line or group of
lines, use the authorization command in line template configuration mode. To disable authorization, use the
no form of this command.
authorization {commands| exec | eventmanager} {default| list-name}
no authorization {commands| exec | eventmanager}
Syntax Description
Enables authorization on the selected lines for all commands.commands
Enables authorization for an interactive (EXEC) session.exec
Applies the default method list, created with the aaa authorization command.default
Sets eventmanager authorization method. This method is used for the embedded
event manager.
eventmanager
Specifies the name of a list of authorization methods to use. If no list name is
specified, the system uses the default. The list is created with the aaa
authorization command.
list-name
Command Default
Authorization is not enabled.
Command Modes
Line template configuration
Command History
ModificationRelease
This command was introduced.Release 2.0
Usage Guidelines
After you use the aaa authorization command to define a named authorization method list (or use the default
method list) for a particular type of authorization, you must apply the defined lists to the appropriate lines for
authorization to take place. Use the authorization command to apply the specified method lists (or, if none
is specified, the default method list) to the selected line or group of lines.
Task ID
OperationsTask ID
read, writeaaa
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
26 OL-24740-01
Authentication, Authorization, and Accounting Commands
authorization (line)

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English