Cisco CRS User Manual

show radius dead-criteria
To obtain information about the dead server detection criteria, use the show radius dead-criteria command.
show radius dead-criteria host ip-addr [auth-port auth-port] [acct-port acct-port]
Syntax Description
Specifies the name or IP address of the configured RADIUS server.
host ip-addr
(Optional) Specifies the authentication port for the RADIUS server. The
default value is 1645.
auth-port auth-port
(Optional) Specifies the accounting port for the RADIUS server. The
default value is 1646.
acct-port acct-port
Command Default
The default values for time and tries are not fixed to a single value; therefore, they are calculated and fall
within a range of 10 to 60 seconds for time and 10 to 100 for tries.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
Task ID
OperationsTask ID
readaaa
Examples
The following sample output is for the show radius dead-criteria command:
RP/0/RP0/CPU0:router# show radius dead-criteria host 12.26.49.12 auth-port 11000 acct-port
11001
Server: 12.26.49.12/11000/11001
Dead criteria time: 10 sec (computed) tries: 10 (computed)
This table describes the significant fields shown in the display.
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
84 OL-24740-01
Authentication, Authorization, and Accounting Commands
show radius dead-criteria

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English