Cisco CRS User Manual

radius-server dead-criteria tries
To specify the number of consecutive timeouts that must occur on the router before the RADIUS server is
marked as dead, use the radius-server dead-criteria tries command. To disable the criteria that were set,
use the no form of this command.
radius-server dead-criteria tries
no radius-server dead-criteria tries
Syntax Description
Number of timeouts from 1 to 100. If the tries argument is not configured, the number of
consecutive timeouts ranges from 10 to 100, depending on the transaction rate of the server
and the number of configured retransmissions.
The tries criterion must be met for the server to be marked as
dead.
Note
tries
Command Default
If this command is not used, the number of consecutive timeouts ranges from 10 to 100, depending on the
transaction rate of the server and the number of configured retransmissions.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
If the server performs both authentication and accounting, both types of packet are included in the number.
Improperly constructed packets are counted as though they were timeouts. All transmissions, including the
initial transmit and all retransmits, are counted.
If you configure the radius-server dead-criteria tries command before the radius-server deadtime
command, the radius-server dead-criteria tries command may not be enforced.
Note
Task ID
OperationsTask ID
read, writeaaa
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
48 OL-24740-01
Authentication, Authorization, and Accounting Commands
radius-server dead-criteria tries

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English