Chapter 6 Troubleshooting the VG248
Displaying Status and Configuration Settings
6-18
Cisco VG248 Analog Phone Gateway Software Configuration Guide
OL-1209-02
To display port status, perform these steps:
Step 1 From the main screen, choose Display.
Step 2 Choose Port status.
The Port status indicates information about the status of the handset of the analog
device connected to the port and about the link to Cisco CallManager.
Step 3 Use the information in Table 6-5 to interpret the port status.
Table 6-5 Port Status
Status Description
Handset Status
OnHook Not currently in use.
OffHook User has lifted the handset.
Ringing Incoming call to this port.
OnCall A call has been established and voice packets are moving across the network.
Cisco CallManager Link Status
Down Link is not up (either because the port is not enabled or because of a temporary
failure).
Register Port is registering with Cisco CallManager
<directory number> Directory number for the port displays indicating that the port is up and
available for use.
Unregister Unregistering from Cisco CallManager. Displays if port is being disabled or
reset.
PeerInUse The port’s directory number is in use by another phone that shares the directory
number. The port is not available for use while a call is active on the other
phone.
KeepCall The Cisco CallManager link has gone down, but the call that was in progress
is being maintained.
To Next Page
Loading...
Need help?
General