5-25
Cisco VG248 Analog Phone Gateway Software Configuration Guide
OL-1209-02
Chapter 5 Integrating Cisco CallManager with Voice Mail Systems Using SMDI
Configuring SMDI Settings on the VG248
Before You Begin
Follow these guidelines for enabling this setting based on your configuration:
• Basic—Enable this on the VG248 system.
• Chained—Enable this on only one of the VG248s in a chain, and for
simplicity, set it on the one directly connected to the voice mail system.
• Multiplexing—Enable this on one VG248 connected to each
Cisco CallManager cluster.
Step 1 From the main menu, choose Configure.
Step 2 Choose SMDI.
Step 3 Choose Forward MWIs to CallManager.
Step 4 Choose one of the following:
• yes
• no
Forwarding MWIs to Async 2
You can specify whether the VG248 forwards SMDI MWI commands received
from the voice mail system to the next device in the SMDI chain.
Before You Begin
Follow these guidelines for enabling this setting based on your configuration:
• Chained—Enable this setting on all VG248 devices except the last device in
the chain on which you have set Forward MWIs to CallManager to yes.
• Multiplexed—Enable this setting on all VG248 devices if you are connecting
to a legacy PBX system. Otherwise, follow the guidelines for the chained
configuration.
Step 1 From the main menu, choose Configure.
Step 2 Choose SMDI.
Step 3 Choose Forward MWIs to Async 2.
To Next Page
Loading...
Need help?
General