Chapter 2 Getting Started with the VG248
Configuring Network Settings
2-6
Cisco VG248 Analog Phone Gateway Software Configuration Guide
OL-1209-02
Step 3 Choose Use DHCP.
Step 4 Press Enter to toggle between yes (use DHCP) and no (do not use DHCP).
If you use DHCP, you can only modify the host name; you cannot modify the
other network settings. See the “Setting the Host Name” section on page 2-7 for
details.
If you do not use DHCP, you must enter the additional network settings. See these
sections for details:
• Setting the Host Name, page 2-7
• Setting the IP Address, page 2-7
• Setting the Subnet Mask, page 2-8
• Setting the Default Router, page 2-8
• Setting the DNS Server, page 2-9
• Setting the Domain Name, page 2-9
Renewing IP Address from DHCP
You might need to renew the IP address automatically assigned to the VG248. For
example, if you have changed the physical location of the VG248 from one subnet
to another or if you need assistance troubleshooting a connectivity problem.
To renew an IP address assigned by DHCP, follow these steps:
Step 1 From the main menu, choose Configure.
Step 2 Choose Network interface.
Step 3 Choose Renew DHCP.
To Next Page
Loading...
Need help?
General