3-7
Cisco VG248 Analog Phone Gateway Software Configuration Guide
OL-1209-02
Chapter 3 Configuring the Telephony Settings on the VG248
Changing the Hook Flash Timer for Analog Phones
Changing the Hook Flash Timer for Analog Phones
The hook flash timer is the length of time before the hook flash indicates a
time-out (or call disconnect). The hook flash timer setting is based on the country
of origin of the analog phones. When you set the country code on the VG248, the
hook flash timer is automatically set to the default for that country.
However, you can modify this setting, if desired.
To change the hook flash timer, follow these steps:
Step 1 From the main menu, choose Configure.
Step 2 Choose Telephony.
Step 3 Choose Hook flash timer.
Step 4 Choose the appropriate hook flash timer value for your analog phones.
Setting the Port Enable Policy
To configure the ports on the VG248 and the features required for the analog
devices connected to the ports, you must add them to the Cisco CallManager
database.
The port enable policy on the VG248 determines whether the VG248 can enable
a port and register the phone in Cisco CallManager.
Before You Begin
The port enable policy interacts with the auto-registration settings in
Cisco CallManager. Review the following explanations before choosing a port
enable policy:
To Next Page
Loading...
Need help?
General