Chapter 2 Getting Started with the VG248
Configuring SNMP Settings
2-14
Cisco VG248 Analog Phone Gateway Software Configuration Guide
OL-1209-02
Configuring System Name
The system name on the VG248 corresponds to the sysName variable defined in
RFC 1213.
To specify the system name of the VG248 to the network management system
perform these steps:
Step 1 From the main menu, choose Configure.
Step 2 Choose SNMP.
Step 3 Choose System name.
Step 4 Enter the system name of the VG248.
Configuring Location
The location on the VG248 corresponds to the sysLocation variable defined in
RFC 1213.
To add the location of the VG248 in your network or on your site, perform these
steps:
Step 1 From the main menu, choose Configure.
Step 2 Choose SNMP.
Step 3 Choose Location.
Step 4 Enter the location of the VG248.
Configuring Trap Settings
You can configure the VG248 to notify up to four network management systems
when certain significant system events occur. You can also specify the IP address
for the network management system that is acting as a trap receiver. See the
“Understanding Trap Support” section on page 1-11 for information about
supported trap types.
To Next Page
Loading...
Need help?
General