Daewoo MATIZ User Manual

MASTER CYLINDER 4B–5
DAEWOO M-150 BL2
MAB4B002
2. Install the brake pipe fittings to the master cylinder.
Tighten
Tighten the fittings to 16 NSm (12 lb-ft).
3. Connect the electrical connector.
4. For vehicles with the non–ABS braking system, install
the proportioning valve. Refer to “Proportioning
Valve” in this section.
5. Install the air filter assembly. Refer to Section 1B, En-
gine Mechanical.
6. Bleed the brake system. Refer to Section 4A, Hy-
draulic Brakes.
D17A517A
BRAKE FLUID RESERVOIR
Removal Procedure
1. Remove the fluid level switch connector. Refer to
“Brake Fluid Level Switch” in this section.
2. Remove the reservoir.
D Drain the brake fluid.
D Remove the screw (1).
D Remove the fluid reservoir using a flathead screw-
driver (2).
Notice: Do not force one side strongly to prevent dam-
age of reservoir when removing the reservoir.
D17A518A
Installation Procedure
Important: Use only Daewoo recommended brake fluid.
1. Install the reservoir with the screw.
Tighten
Tighten the screw to 4 NSm (35 lb-ft).
2. Install the fluid level switch connector. Refer to “Brake
Fluid Level Switch” in this section.
3. Add brake fluid.
4. Bleed the brake system. Refer to Section 4A, Hy-
draulic Brakes.
MAB4B003
PROPORTIONING VALVE (FOR
VEHICLE WITH THE NON–ABS
BRAKING SYSTEM)
1. Remove the proportioning valve.
D Loosen the brake pipe fittings–to–proportioning
valve (1).
D Remove the proportioning valve (2).
D Plug the opening in the proportioning valve and
brake pipe fitting to prevent fluid loss or contamina-
tion.

Daewoo MATIZ Specifications

General

Brand	Daewoo
Model	MATIZ
Category	Automobile
Language	English