7A–10 HEATING AND VENTILATION SYSTEM
DAEWOO M-150 BL2
BLOWER ELECTRICAL
Step
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Action
Value(s)
Yes
No
ÁÁ
1
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Verify the customer’s complaint.
Are the customer’s concerns verified.
ÁÁÁ
–
ÁÁÁÁÁ
Go to Step 2
ÁÁÁÁ
System OK
ÁÁ
2
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Check the blower.
Does the blower run at any speed?
ÁÁÁ
–
ÁÁÁÁÁ
System OK
ÁÁÁÁ
Go to Step 3
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
3
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
1. Disconnect the power connector from the blower
motor under the dashboard on the passenger side
of the vehicle.
2. Use an ohmmeter check the resistance between
the 1 terminal of the blower motor connector and
each step with the blower switch place each
position.
Does the ohmmeter show the specified value of the
each position?
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
Refer to
“Specifica-
tions” in this
section.
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
Go to Step 4
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
Go to Step 5
ÁÁ
4
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Replace the blower motor.
Is the repair complete?
ÁÁÁ
–
ÁÁÁÁÁ
System OK
ÁÁÁÁ
Go to Step 7
ÁÁ
5
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Check the fuse Ef6.
Is the fuse blown?
ÁÁÁ
–
ÁÁÁÁÁ
Go to Step 6
ÁÁÁÁ
Go to Step 7
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
6
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
1. Turn the ignition ON.
2. Use a short detector to locate a possible short.
D From the fuse Ef6 to the blower switch.
D From the blower swtich to the blower resistor.
D From the blower resistor to the blower motor.
3. Repair any short.
4. Replace any blown fuse.
Is the repair complete?
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
–
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
System OK
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
–
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
ÁÁ
7
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
1. Turn the ignition ON.
2. Disconnect the power connector from the blower
motor.
3. Use a test lamp to locate a possible short.
D From the terminal 2 of the motor connector to
the terminal 3 of the motor switch connector.
D From the terminal 2 of the motor connector to
the terminal 4 of the motor switch connector.
D From the terminal 2 of the motor connector to
the terminal 5 of the motor switch connector.
D From the terminal 2 of the motor connector to
the terminal 6 of the motor switch connector.
Does the test lamp light ON?
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
–
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
ÁÁÁÁÁ
Go to Step 9
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
ÁÁÁÁ
Go to Step 8
ÁÁ
8
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Replace the blower resistor.
Is the repair complete?
ÁÁÁ
–
ÁÁÁÁÁ
System OK
ÁÁÁÁ
Go to Step 10
ÁÁ
9
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Replace the blower motor switch.
Is the repair complete?
ÁÁÁ
–
ÁÁÁÁÁ
System OK
ÁÁÁÁ
–
ÁÁ
10
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
1. Check the ground of the blower motor.
2. Repair the ground of the blower motor.
Is the repair complete?
ÁÁÁ
–
ÁÁÁÁÁ
System OK
ÁÁÁÁ
–