ENGINE CONTROLS 1F–95
DAEWOO M-150 BL2
DTC P0137 – Heated Oxygen Sensor Low Voltage
Step Action Value(s) Yes No
1
Perform an Euro On-Board Diagnostic (EOBD)
System Check.
Is the system check complete?
–
Go to Step 2
Go to
“On-Board
Diagnostic
System Check”
2
1. Turn the ignition switch to ON, with the engine
OFF.
2. Install a scan tool.
3. Engine at operating temperature.
4. Run the engine at 1,200rpm.
Does the scan tool the downstream oxygen (O2)
sensor1 voltage within the value specified? 0.07–0.352V Go to Step 4 Go to Step 3
3
Does the scan tool the heated oxygen (O2) sensor1
voltage within the value specified?
0.1V Go to Step 9
Go to
“Diagnostic
Aids”
4
1. Turn the ignition switch to LOCK.
2. Disconnect the Heated O2 sensor connector and
engine control module (ECM) connector.
3. Check the Heated O2 sensor wire between the
Heated O2 sensor connector terminal 4 and ECM
connector terminal 35 for short to ground.
Is the problem found?
–
Go to Step 5 Go to Step 6
5
1. Repair the wire of the connector terminal as
needed.
2. Clear the DTCs from the ECM.
3. Road tests the vehicle.
4. Perform the diagnostic system check.
Is the repair complete?
–
System OK
–
6
1. Turn the ignition switch to LOCK.
2. Disconnect the Heated O2 sensor connector and
engine control module (ECM) connector.
3. Check the O2 sensor wire between the O2 sensor
connector terminal 3 and ECM connector terminal
76 for short to ground.
Is the problem found?
–
Go to Step 7 Go to Step 8
7
1. Repair the wire of the connector terminal as
needed.
2. Clear the DTCs from the ECM.
3. Road tests the vehicle.
4. Perform the diagnostic system check.
Is the repair complete?
–
System OK
–
8
1. Turn the ignition switch to LOCK.
2. Replace the Heated O2 sensor.
3. Road tests the vehicle.
4. Perform the diagnostic system check.
Is the replacement complete?
–
Go to Step 10
–
9
1. Turn the ignition switch to LOCK.
2. Replace the ECM.
3. Road tests the vehicle.
4. Perform the diagnostic system check.
Is the replacement complete?
–
Go to Step 10
–