Daewoo MATIZ User Manual

7B -- 22 MANUAL CONTROL HEATING, VENTILATION, AND AIR CONDITIONING SYSTEM
DAEWOO M-150 BL2
D18B514A
D Remove the condenser mounting nuts (3).
D Push the top of the condenser (4).
D Take off the condenser from the lower bracket by
lifting the condenser (5).
D Remove the c ondenser (6).
D18B515B
Installation Procedure
Important: Discard the removed O--rings.
1. Install the condenser with the nuts.
Tighten
Tighten the condenser mounting nuts to 4 NSm(36lb-
in).
D18B516B
2. Tighten the fittings and the bolt.
Tighten
D Tighten the condenser pipe--to--compressor pipe
fitting to 23 NSm (17 lb-ft) (1).
D Tighten the condenser pipe--to--receiver dryer pipe
fitting to 14 NSm (10.5 lb-ft) (2).
3. Evacuate and recharge the system. Refer to “Dis-
charging, Adding Oil, Evacuating, and Charging Pro-
cedures for A/C System” in this section.
4. Install the front bumper fascia. Refer to Section 9O,
Bumpers and Fascias.
5. Connect the negative battery cable.
D108B517
A/C HIGH PRESSURE PIPE LINE
(Left--Hand Drive Shown, Right--Hand
Drive Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the front bumper fascia. Refer to Section
9O, Bumpers and Fascias.
3. Discharge and recover the refrigerant. Refer to “Dis-
charging, Adding Oil, Evacuating, and Charging Pro-
cedures for A/C System” in this section.
4. Remove the A/C high pressure pipe line between the
compressor and the condenser.
D Remove the bolt securing the high pressure pipe
line to the compressor (1).

Daewoo MATIZ Specifications

General

Brand	Daewoo
Model	MATIZ
Category	Automobile
Language	English