Datalogic PowerScan PD9130 User Manual

Enter/Exit Programming Mode
Product Reference Guide 133
Datalogic 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for Datalogic 2 of 5
Length Control. Length 2 is the maximum label length if in Variable Length
Mode, or the second fixed length if in Fixed Length Mode. The length
includes the bar code’s da
ta characters only.
The length can be set from 2 to 50 characters. A setting of 00 specifies to ignore this
length (only one fixed length). See
Set Length 2 on page 298 for more detailed
programming instructions.
Select Datalogic 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by
digits from the Alphanumeric characters in
Appendix D, Keypad representing your desired
character(s). End by scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start
again at the beginning.
CANCEL
50 = Length 2 is 50 Characters
DEFAULT

Datalogic PowerScan PD9130 Specifications

General

Brand	Datalogic
Model	PowerScan PD9130
Category	Barcode Reader
Language	English