Datalogic PowerScan PD9130 User Manual

Enter/Exit Programming Mode
236 PowerScan™ PD9130/PBT9100/PM9100
Set PIN Code
Determine the desired characters for the PIN code, then convert to hexadec-
imal using the ASCII Chart on the inside back cove
r of this manual. See
page 312 for detailed information and examples for setting this feature.
Set 4-character Bluetooth PIN Code
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the hexadecimal digits from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code twice.
To configure this feature, scan
the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the hexadecimal digits from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT
bar code twice.
Set 16-character Bluetooth PIN Code
CANCEL
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
Default 4-char PIN Code is 1234
Default 16-char PIN Code is 1234567890ABCDEF

Datalogic PowerScan PD9130 Specifications

General

Brand	Datalogic
Model	PowerScan PD9130
Category	Barcode Reader
Language	English