Datalogic PowerScan PD9130 User Manual

Enter/Exit Programming Mode
Product Reference Guide 35
Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value fr
om 0 to 0xFF can be selected.
See page 292 for more information on setting this feature.
Select Disable Character Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning
the ENTER
/EXIT bar code twice.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
0x44 = Disable Character is ‘D’
Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value fr
om 0 to 0xFF can be selected.
See page 293 in “References” for more information on setting this feature.
Select Enable Character Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning
the ENTER
/EXIT bar code twice.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
0x45 = Enable Character is ‘E’

Datalogic PowerScan PD9130 Specifications

General

Brand	Datalogic
Model	PowerScan PD9130
Category	Barcode Reader
Language	English