Datalogic PowerScan PD9130 User Manual

Enter/Exit Programming Mode
266 PowerScan™ PD9130/PBT9100/PM9100
Set String ID
Sets the identifier of the predefined strings.
Set String ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by 6 digits from the Alphanumeric
characters in
Appendix D, Keypad .
The ID characters must be
represented by their hexa-
decimal ASCII code; if the first 2 digits are 0, this fea-
ture is disabled. End by scanning the
ENTER/EXIT bar
code twice.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Set String Header
Sets the header of the predefined strings.
Set String Header
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by 32 digits from the Alphanumeric
characters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII representa-
tion of the desired characters. If less than the
e
xpected string of 16 characters are selected, scan the
ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTE
R/EXIT bar code twice.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

Datalogic PowerScan PD9130 Specifications

General

Brand	Datalogic
Model	PowerScan PD9130
Category	Barcode Reader
Language	English