Enter/Exit Programming Mode
268
PowerScan™ PD9130/PBT9100/PM9100
ADDITIONAL FEATURES FOR 16-KEY MODELS
See also Function Keys Configuration (16-key models only) on page 263.
Last Code Shown Timeout
After the CODE transmission, the last code read will be shown on the display
for a configurable timeout (LAST CODE SHOWN TOUT).
The standard DISPLAY OFF TIMEOUT (see
page 253
) has a higher priority than the
LAST CODE SHOWN TOUT, so the two parameters sho
uld be combined to get the desired
result.
.
Last Code Shown Timeout
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at l
eft followed by 2 digits (00-63 by 01) from the
Alphanumeric characters in
Appendix D, Keypad.
End by scanning the ENTER/EXIT bar code twice.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
To Next Page
Loading...
Need help?
General
