Enter/Exit Programming Mode
Product Reference Guide
55
INDIVIDUALLY SET LABEL ID
This feature configures a Label ID individually for a single symbology. To
set, first define whether you want it as a prefix or suffix by scanning a label
below. Then turn to Label ID Symbology Selection, starting on page 56 to
select the symbology you want to set, fol
lowed by up to 3 characters from
the ASCII Chart at the back of this manual. See "Label ID:
Set Individually Per
Symbology" on page 304 for detailed instructions on setting this feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or
suffix for a given symbology type.
DEFAULT
Label ID Transmission = Disable
Label ID Transmission = Enable as Prefix
Label ID Transmission = Enable as Suffix
CANCEL
Make a mistake? Scan the CANCEL bar code
to abort and not save the entry string. You
can then start again at the beginning.
To Next Page
Loading...
Need help?
General
