Setup
20
PowerScan™ PD9130/PBT9100/PM9100
Linking to a Bluetooth Adapter in HID mode
1. Install any drivers provided with the Bluetooth adapter.
2. Scan the
Link to PC in HID
label below.
3. Use the host computer’s Bluetooth m
anager to “Discover new devices”
and select "Datalogic Scanner." If you receive an error message, it may
be necessary to disable security on the device.
4. Use a text editor to see incoming data on the port designated by the
c
omputer's Bluetooth manager.
Link to PC in HID
The Powerscan BT9500 can be set up to require a PIN code when connecting.
If you want to set up a PIN, or when adding new equipment to a system that
uses a custom security PIN, please see
"Bluetooth PIN Code"
starting on
page 235 for more information.
Power Off
Scan the bar code below to shut off power to the handheld until the next
trigger pull
. This function only applies to the wireless models.
Power Off
To Next Page
Loading...
Need help?
General
