ENTER/EXIT PROGRAMMING MODE ETHERNET INTERFACE
92
POWERSCAN™ PD/PM/PBT9600
LOGGER Socket Port
This parameter will allow the identification of a network service on an IP network (the
Internet). It is a mapping to the underlying TCP-IP socket port number used for monitor-
ing data transfer. This Socket works also for industrial protocol Profinet or Ethernet IP.
DATA Flow Control Selection
The Datalogic Flow Control Mode is a powerful way to manage and optimize the com-
munication with the Fieldbus Master. By enabling the FCM a few bytes of the exchange
areas are reserved for driver operations and the rest are used by the application layer.
For more details see FBC9080 Fieldbus Converter Software Integration Guide.
Logger Socket Port
$CETLP
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by 5 digits from the Alphanumeric characters
in Appendix G, Keypad representing your desired
character(s).
Exit programming mode by scanning the ENTER/
EXIT barcode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
52000
$CETDO00\r
Flow Control Disable
Flow Control Enable
$CETDO01\r
$CETDO02\r
Consistency Enable
Flow control and consistency enable
$CETDO03\r
To Next Page
Loading...
Need help?
General
