Datalogic PowerScan Series User Manual

ENTER/EXIT PROGRAMMING MODE 1D SYMBOLOGIES
196 POWERSCAN™ PD/PM/PBT9600
ABC Codabar Dynamic Concatenation Timeout
This parameter specifies the timeout in 10-millisecond ticks used by the ABC Codabar
Dynamic Concatenation Mode. The timeout can be set within a range of 05 to 255 in
10ms increments. A setting of zero specifies no delay.
ABC Codabar Force Concatenation
When ABC Codabar Concatenation is enabled and Force Concatenation is disabled, both
Codabar stand alone labels and ABC Codabar concatenated labels are transmitted.
When ABC Codabar Concatenation is enabled and Force Concatenation is enabled only
ABC Codabar concatenated labels are transmitted while Codabar stand alone labels are
not transmitted.
Force Concatenation has no effect if the ABC Codabar Concatenation is disabled. The
Force Concatenation mode has effect both in Static and Dynamic Concatenation Modes.
Select ABC Codabar Dynamic Concatenation
Timeout Setting
$CCBDT
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix G, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

Timeout = 20 (200 msec)
$CCBFC00

ABC Codabar Force Contatenation = Disable
ABC Codabar Force Concatenation = Enable
$CCBFC01

Datalogic PowerScan Series Specifications

General

Brand	Datalogic
Model	PowerScan Series
Category	Barcode Reader
Language	English