Datalogic PowerScan Series User Manual

254 POWERSCAN™ PD/PM/PBT9600
Arrow Down String (4-key models only)
Associate a pre-defined string to the Arrow Down key
Legend for Arrow UP (4-key models only)
Set the string to be shown in display legend for arrow up Key
Set string for Arrow Down Key
$CDADS
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left. Define the label string by further scanning 32
digits from the Alphanumeric characters in
Appendix G, Keypad.
The digits must be the hexadecimal ASCII represen-
tation of the desired characters; if less than the
expected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Set legend for Arrow Up Key
$CPWSF
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 4 couples of digits from the Alpha-
numeric characters in Appendix G, Keypad. End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

3D00

Datalogic PowerScan Series Specifications

General

Brand	Datalogic
Model	PowerScan Series
Category	Barcode Reader
Language	English