ENTER/EXIT PROGRAMMING MODE DISPLAY AND KEYBOARD FEATURES
248
POWERSCAN™ PD/PM/PBT9600
DISPLAY AND KEYBOARD FEATURES
Two keyboard models are available, the 4-key model and the 16-key model. The following
section contains configuration parameters that are common and applicable to both keypad
models, unless specifically labeled as “4-key models only” or “16-key models only”.
For more items for the 16-key model, see
Additional Features for 16-key Models, starting
on page 264
.
Display Operating Mode
Select the operating mode of the display. Options are:
• Normal Mode: Display not cleared, no echo of the code on Display.
• Local Echo: Display cleared after decode, echo of the code on display.
• Clear display after decode: Display is cleared after decode, no echo.
Display Off Timeout
Sets the timeout for display, backlight and keyboard.
$CDIMD00
Normal Mode = Display not cleared
Local echo mode
$CDIMD01
$CDIMD02
Clear display after decode
Set Display Off Timeout
$CDIOT
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by two digits (01-99 sec.) from the
Alphanumeric characters in Appendix G, Keypad rep-
resenting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
08 = 8 second delay
To Next Page
Loading...
Need help?
General
