To Next Page

To Previous Page

MICRO PDF417 ENTER/EXIT PROGRAMMING MODE

PRODUCT REFERENCE GUIDE

235

Micro PDF417 Length Control

This feature specifies either variable length decoding or fixed length decoding for this

symbology.

Variable Length:

For variable length decoding, a minimum and maximum length may

be set.

Fixed Length:

For fixed length decoding, two different lengths may be set.

Micro PDF417 Set Length 1

Specifies one of the bar code lengths for "Micro PDF417 Length Control" on page 235.

Length 1 is the minimum label length if in Variable Length Mode, or the first fixed length

if in Fixed Length Mode. Length includes the bar code’s data characters only. Characters

can be set from 0001 to 0366 characters (pad with zeroes) in increments of 01. Any

value greater than 0366 will be considered to be 0366.

See "

Set Length 1" on page 341 for detailed instructions on setting this feature.

$CMILC00



Micro PDF417 Length Control = Variable Length

Micro PDF417 Length Control = Fixed Length

$CMILC01

Select Micro PDF417 Length 1 Setting

$CMIL1

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in Appendix G, Keypad represent-

ing your desired character(s). End by scanning the

ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



0001 = Length 1 is 1 Character

Datalogic PowerScan Series User Manual

Questions and Answers: