ENTER/EXIT PROGRAMMING MODE 1D SYMBOLOGIES
202
POWERSCAN™ PD/PM/PBT9600
Code 11 Set Length 1
This feature specifies one of the bar code lengths for "Code 11 Length Control" on page
201
. Length 1 is the minimum label length if in Variable Length Mode, or the first fixed
length if in Fixed Length Mode. Length includes the bar code’s check and data charac-
ters.
The length can be set from 2 to 50 characters. See "
Set Length 1" on page 341 for more
detailed programming instructions.
Code 11 Set Length 2
This feature specifies one of the bar code lengths for "Code 11 Length Control" on page
201
. Length 2 is the maximum label length if in Variable Length Mode, or the second
fixed length if in Fixed Length Mode. Length includes the bar code’s check and data
characters.
The length can be set from 2 to 50 characters. A setting of 00 specifies to ignore this
length (only one fixed length). See "
Set Length 2" on page 342 for more detailed pro-
gramming instructions.
Select Code 11 Length 1 Setting
$CC1L1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix G, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 1 = 04 (4 characters)
Select Code 11 Length 2 Setting
$CC1L2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix G, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 = 50 (50 characters)
To Next Page
Loading...
Need help?
General
