MOUNTING INSTRUCTIONS
PRODUCT REFERENCE GUIDE
21
Portable Desktop Mounting
For desktop mounting, if portability of the base station is required, the mounting plate
can be used. There are two ways this can be done: (1) base station fast release by first
fixing the mounting plate onto a flat surface so the base station can be slid off and on,
or (2) connection module fast release by fixing the mounting plate to the connection
module and then fixing both of them onto a flat surface so only the cradle can be slid off
while the connection module will remain on the desk.
Base Station Fast Release - Mounting the Plate
1. Affix the mounting plate onto the desired mounting surface using four screws
through the holes highlighted in the figure below.
2. Remove the adhesive strips protecting the mounting tabs on the base station.
Adhesive
strips
To Next Page
Loading...
Need help?
General
