ARROW KEYS MODE (4-KEY MODELS ONLY) ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
253
Arrow Keys Mode (4-key models only)
Configure the Arrow Keys functionality type. Two options are available:
Function Keys Action Select mode:
When in this mode, arrow keys are used to select
one of the 3 possible actions associated to the Function Keys. To associate actions to the
Function keys, see
Configure Actions for Function Keys, starting on page 256.
String Association Mode:
When in this mode, each one of the arrow keys can be pro-
grammed to display and transmit a pre-defined string.
Arrow Up String (4-key models only)
Associate a pre-defined string to the Arrow Up key
$CDIAC00
SHIFT Mode
STRING Mode
$CDIAC01
Set string for Arrow Up Key
$CDAUS
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left. Define the label string by further scanning 32
digits from the Alphanumeric characters in
Appendix G, Keypad.
The digits must be the hexadecimal ASCII represen-
tation of the desired characters; if less than the
expected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0x3D000000000000000000000000000000
To Next Page
Loading...
Need help?
General
