To Next Page

To Previous Page

ENTER/EXIT PROGRAMMING MODE 1D SYMBOLOGIES

170

POWERSCAN™ PD/PM/PBT9600

I 2 of 5 Set Length 2

This feature specifies one of the bar code lengths for "I 2 of 5 Length Control" on page

169

. Length 2 is the maximum label length if in Variable Length Mode, or the second

fixed length if in Fixed Length Mode. The length includes the bar code’s check and data

characters. The length can be set from 2 to 50 characters in increments of two. A setting

of 00 specifies to ignore this length (only one fixed length). See "

Set Length 2" on page

342

for more detailed programming instructions.

Select I 2 of 5 Set Length 2 Setting

$CI2L2

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in Appendix G, Keypad represent-

ing your desired character(s). End by scanning the

ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



Length 2 = 50 (50 characters)

Datalogic PowerScan Series User Manual

Questions and Answers: