Installing Blade Components 205
PowerEdge M910, M710, M710HD, M610, and M610x
In these blades, the SD card is an unmanaged persistent storage card. A
hypervisor may be installed using this card.
NOTE: For M910 and M710HD, the iDRAC6 vFLASH card can be set to IDSDM
function along with the SD card by setting the Redundancy option to Mirror mode in
the Integrated Devices screen of system setup. When the IDSDM function is
enabled, the vFlash functionality of the iDRAC6 vFlash card gets disabled.
NOTE: In IDSDM (M910 and M710HD only), the SD card in the lower card slot is the
primary card (SD1) and the SD card in upper card slot is the secondary card (SD2).
1
Remove the blade. See "Removing a Blade" on page 145.
2
Install the
SD
card in the lower card slot. See Figure 3-25.
3
Install the blade. See "Installing a Blade" on page 148.
Figure 3-25. Installing and Removing an SD Card (PowerEdge M910, M710, M710HD,
M610, and M610x)
1 SD card in lower card slot 2 iDRAC6 Enterprise card
To Next Page
Loading...
Need help?
General