Troubleshooting Your System 301
Troubleshooting the Blade Board
1
Remove the blade. See "Removing a Blade" on page 145.
2
Open the blade. See "Opening the Blade" on page 149.
3
Verify that the iDRAC6 Enterprise Card is installed and fully seated on the
system board. See "iDRAC6 Enterprise Card" on page 214.
4
Clear the blade NVRAM.
See "Blade System Board Jumper Settings" on page 309 for the location of
the NVRAM_CLR jumper.
5
If there is a still a problem with the blade, remove and reinstall the blade.
See "Installing a Blade" on page 148.
6
Turn on the blade.
7
Run the system board test in the system diagnostics. See "Running System
Diagnostics" on page 303.
If the tests fail, see "Getting Help" on page 337.
To Next Page
Loading...
Need help?
General