AS Series Operation Manual
6-12
Additional remark
After you click a network and press Enter on the keyboard, you can edit a box. Press Enter on the keyboard to
edit the next box in the network. Press Tab on the keyboard to select the next network. Use the keyboard to edit
boxes. After you finish the editing, press Enter on the keyboard to jump to the next box. Press Esc on the
keyboard to exit editing.
If you have declared symbols, click in a box, or press Page Down on the keyboard when you edit the box.
The symbols on the drop-down list are the symbols that you can assign to the object. Select a symbol with the
mouse or the up/down key on the keyboard. Refer to Chapter 6 in the ISPSoft User Manual for more
information about symbols.
6.5.3
Basic Editing ─ Inserting a Network and Typing an Instruction
Click on the toolbar to select a network. Click on the toolbar to place another network above the
selected network. In this example, Network 2 is under Network 1.
Create a contact and a coil by clicking and on the toolbar or by typing instructions.
(1) Click the line in Network 2.
To Next Page
Loading...
Need help?
General
