Digital-Ally DVM-800 User Manual

860-00186-00 Rev J
Digital Ally Inc.| Device Configuration
3-22
Latitude
The vehicle home base latitude coordinate in an integer decimal format (i.e.; lat = 38.89171).
Longitude
The vehicle home base longitude coordinate in an integer decimal format (i.e.; long =
-94.670956).
Max Distance
This is the distance in miles that the vehicle can travel from the home base. If the vehicle travels
beyond the specified distance, an event record will be triggered. A value of zero (0) disables this
event trigger.
Locations of Interest
Locations of interest are geographical areas identified by latitude, longitude and a radius using the GPS
antenna. These areas are generally considered restricted or off limits. If the vehicle enters, or remains
in a location of interest for a configurable amount of time, the DVM will automatically start a recorded
event. Up to 21 different Locations of Interest can be configured. Below are the configurable items:
Time in Location
Enter the allowable time in this location before an event recording is triggered (days, hours and
minutes). The minimum time in a location of interest before an event is triggered is 1 minute. To
disable all unauthorized zones set the time to 0 days, 0 minutes, and 0 seconds.
Latitude
Enter the location(s) latitude in an integer decimal format (i.e.; 38.89171). To disable a location,
the latitude, longitude, and radius parameters must all be zero (0)
Longitude
Enter the location(s) longitude in an integer decimal format (i.e.; -94.670956). To disable a
location, the latitude, longitude, and radius parameters must all be zero (0).
Radius (miles)
Enter the radius of the unauthorized location in miles. To disable an unauthorized location, the
latitude, longitude, and radius parameters must all be zero (0).
ONCE THE DESIRED SETTINGS HAVE BEEN ENTERED, CLICK AND
PROCEED TO NEXT PAGE TO ACTIVATE YOUR DVM-800 SD CARD.

Digital-Ally DVM-800 Specifications

General

Brand	Digital-Ally
Model	DVM-800
Category	Dash Cameras
Language	English