860-00186-00 Rev J
Digital Ally Inc.| Wireless Microphone Operation
5.4 Notification Alert Switch
The switch position determines the notification method provided to the user:
Visible Indicators with audible beep notifications (‘BEEP’)
Visible Indicators with vibratory notifications (‘VIB’)
Covert operation is achieved by putting the switch in the ‘OFF’ position. All
notification methods are disabled.
5.5 Out of Range
1. Depending on the position of the Notification Alert Switch, the Transmitter will alert you
with two audible beeps or two vibrations and the Status indicator will blink in red.
2. Move closer to the receiver base (Cradle) and the link will be re-established once you return to
normal range. The Status indicator will light constant green when link is back to normal
operation.
3. If the link is not re-established within 30 seconds, the Transmitter and Receiver will return to
standby mode.
4. If you went out of range in Standby mode, or the unit reverted to standby mode, re-enter
normal range and press the REC button. Operation will return to normal.
5. If you will be out of range for a long period of time, turn the Transmitter off.
5.6 Charging Information
The Transmitter must be fully charged before initial use and should be done using the in-car Cradle
or optional desktop charging cradle. Typical charge time from a full discharge is approximately 4
hours. To minimize charge time the Transmitter should be powered off.
In some vehicles, the 12VDC receptacle may be controlled by the position of the ignition switch. In
such cases, the Transmitter will only charge when the ignition switch is in the “On” position.
The Lithium-Ion battery built in to the Transmitter will work at full capacity for over 500 charge cycles. If
you notice lower than usual battery life over time, it may be time to replace. Please contact our
Technical Support team for details.