Digital-Ally DVM-800 User Manual

860-00186-00 Rev J
Digital Ally Inc.| Wireless File Transfer
7-1
Section - 7: Wireless File Transfer
The DVM-800 is capable of automatically transmitting video events to your VuVault Server when within
range of an authorized wireless access point, and can wirelessly receive firmware & configuration file
updates. Any authorized user may then playback and analyze video using the VuVault client software
(consult the VuVault Administrator Guide for more information). There are two ways to set up the DVM-
800 wireless transfer: Basic mode and Advanced mode. Decide from the description below which mode
works best for your application. Make sure your wireless access point is powered on and connected to
your network. The included Wi-Fi dongle is required for wireless file transfer.
Basic
During ‘Basic Wi-Fi’ operation, after the event files have been uploaded to the server the
DVM will delete the files from DVM’s primary memory storage. This mode provides no
extra file verification. Once the file has been uploaded to the FTP server, file is deleted
from the DVM. This is the common method for most wireless installations.
Advanced
‘Advanced Wi-Fi’ configuration will only delete the files from the DVM’s primary memory
after VuVault has imported and validated the files.
The wireless transfer operation is configured using the VuVault Admin>Devices>DVM-800 Settings tab,
and the Admin>VuVault Settings>WtmLite tab. Refer to Section 3.9 for DVM configuration instructions,
and the VuVault Wireless Server Setup Guide for instructions on how to configure your VuVault server
to support the wireless file transfer feature. A Wi-Fi dongle for the DVM-800 is required.
Wireless configuration settings (see
Section 3.9)
VuVault Wireless Server configuration
settings (Consult the VuVault Wireless
Server Setup Guide)

Digital-Ally DVM-800 Specifications

General

Brand	Digital-Ally
Model	DVM-800
Category	Dash Cameras
Language	English