Ducati Hypermotard User Manual

Clock setting function (CLOCK)
This function allows setting the clock. To display this
function, access the Setting Menu and select the
"CLOCK" page. To access the setting page, keep
button (4) pressed for 3 seconds. After this time, the
"SETTING..." indicator will be enabled to confirm that
the setting page is active.
On entering this mode, the message “AM” will flash;
-
if you press button (2) "PM" flashes;
- if you press button (2) you will return to the
previous step (if it is 00:00, when switching
between “AM” to “PM”, 12:00 will be
displayed);.
Pressing button (4) gives access to the hour setting
mode; hours start to flash;
- each time you press button (2), the count will
increase cyclically in steps of one hour;
- if button (2) is held pressed, the count will
increase cyclically in steps of one hour every
second (when the button is held depressed, the
hours do not flash).
Pressing button (4) gives access to the minutes
setting mode; minutes start to flash;
- each time you press button (2), the count will
increase cyclically in steps of one minute;
-
if you hold button (2) pressed, the count will
increase cyclically in steps of 1 minute every
second.
- If button (2) is held depressed for over 5 seconds,
minutes will increase by 1 minute every 100 ms
(while button (2) is held depressed, seconds will
not flash).
To confirm (store) the new time setting, press button
(4). The "EXIT" indicator will be automatically
highlighted; press button (4) to quit this page and go
back to the setting menu.
Note
If the battery is cutoff, when the voltage is
restored and at the next Key-On, the clock must be
reset (it starts automatically from 00:00).
102

Ducati Hypermotard Specifications

General

Transmission	6-speed
Frame	Tubular steel trellis frame
Engine Type	L-twin, 4 valves per cylinder, Desmodromic, liquid cooled
Torque	71 lb-ft (96 Nm) @ 7, 250 rpm
Front Brake	2 x 320mm semi-floating discs, radially mounted Brembo Monobloc 4-piston calipers
Rear Brake	245mm disc, 2-piston caliper