Wired Network Connection
24
You can monitor and control your projector, over a network.
To perform these operations, connect the projector to your network, and then
set up your projector and computer.
gg Related Links
• "Connecting to a Wired Network" p.24
• "Selecting Wired Network Settings" p.24
Connecting to a Wired Network
To connect the projector to a wired local area network (LAN), use a 100Base-
TX or 10Base-T network cable. To ensure proper data transmission, use a
Category 5 shielded cable or better.
a
Connect one end of the network cable to your network hub, switch, or
router.
b
Connect the other end of the cable to the projector's LAN port.
Selecting Wired Network Settings
Before you can use the projector on your network, you need to select network
settings on the projector.
a
Make sure you already connected the projector to your wired network
using the LAN port.
a
Press the [Menu] button, select the Network menu, and press [Enter].
b
Select Network Settings and press [Enter].
c
To identify the projector over the network, select Projector Name and
enter a name up to 16 alphanumeric characters long.
To Next Page
Loading...
Need help?
General
